HEIDENHAIN TNC 320 - Inserting a structure block in the program window; Selecting blocks in the program structure window

Programming Aids | Structuring programs
4
180
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
Inserting a structure block in the program window
Select the block after which the structuring block is to be
inserted
Press the SPEC FCT key
Press the PROGRAMMING AIDS soft key
Press the INSERT SECTION soft key
Enter the structuring text
If necessary, change the structure depth with the
soft key
You can also insert structure blocks with the key
combination Shift + 8.
Selecting blocks in the program structure window
If you are scrolling through the program structure window block
by block, the control at the same time automatically moves the
corresponding NC blocks in the program window. This way you can
quickly skip large program sections.