Manual Operation and Setup | Moving the machine axes
13
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
519
Traverse with electronic handwheels
DANGER
Caution: Danger for the operator!
Unsecured connections, defective cables, and improper use are
always sources of electrical dangers. The hazard starts when the
machine is powered up!
Devices should be connected or removed only by authorized
service technicians
Only switch on the machine via a connected handwheel or a
secured connection
The control supports traversing with the following new electronic
handwheels:
HR 510: Simple handwheel without display, data transfer via
cable
HR 520: Handwheel with display, data transfer via cable
HR 550FS: Handwheel with display, data transfer via radio
In addition to this, the control continues to support the cable
handwheels HR 410 (without display) and HR 420 (with display).
Refer to your machine manual.
Your machine tool builder can make additional functions
of the HR 5xx handwheels available.
If you want to use the Handwheel superimp.: function
in a virtual tool axis VT, then we recommend the
handwheel HR 5xx.
Further information: "Virtual tool axis VT", page 440
The portable HR 520 and HR 550FS handwheels feature a display
on which the control shows information. In addition, you can
use the handwheel soft keys for important setup functions, e.g.
presetting or entering and running M functions.
As soon as you have activated the handwheel with the handwheel
activation key, the operating panel is locked. The control shows this
status in a pop-up window on the screen.
To Next Page
Loading...
