Test Run and Program Run | Graphics
15
586
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
15.1 Graphics
Application
In the Program run, single block and Program run, full sequence
operating modes, as well as in the Test Run Operating Mode, the
control graphically simulates a machining operation.
The control features the following views:
Plan view
Projection in three planes
3-D view
In the Test Run operating mode, you can additionally
use the 3-D line graphics.
The graphic depicts the workpiece as if it were being machined
with a cylindrical end mill.
For active tool tables, the control also takes the entries in the
columns LCUTS, T-ANLGE, and R2 into consideration.
The control will not show a graphic if
the current program has no valid workpiece blank definition
no program is selected
with blank form definition with a subprogram, the BLK FORM
block was not yet run
The simulation of programs with 5-axis machining or
tilted machining might run at reduced speed. With the
MOD menu Graphic settings you and decrease the
Model quality and in that way increase the speed of
simulation.
To Next Page
Loading...
