HEIDENHAIN TNC 320 - Page 237

Tools | Tool management (option number 93)
5
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
237
Editing with active form view
If the form view is active, the following functions are available to
you:
Soft key Editing functions, form view
Select the tool data of the previous tool
Select the tool data of the next tool
Select previous tool index (only active if indexing is
enabled)
Select the next tool index (only active if indexing is
enabled)
Open a pop-up window for selection (only available
for selection fields)
Discard all changes made since the form was called
Add tool index
Delete tool index
Copy the tool data of the selected tool
Insert the copied tool data in the selected tool