Fundamentals | Control model, software and features
24
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
New and modified cycle functions 77185x-04
New cycle 258 POLYGON STUD
Cycles 421, 422 and 427 were expanded by the parameters
Q498 and Q531
In Cycle 247 PRESETTING, the preset number from the preset
table can be selected with the corresponding parameter
With Cycles 200 and 203 the behavior of the dwell time at top
has been adapted
Cycle 205 performs deburring on the coordinate surface
With SL cycles, M110 is now taken into account with circles
compensated inwards if it is active during machining
With Cycle 251 Rectangular pocket, M110 is now taken into
account with circles compensated inwards if it is active during
machining
Cycle 225 has been expanded with parameters Q516, Q367 and
Q574. This enables a preset for the specific text position to be
defined or the text length and character height to be scaled
In Cycles 481 to 483, parameter Q340 was expanded with the
input option "2". This makes it possible to check the tool without
changing the tool table
Cycle 251 has been expanded by parameter Q439. The finishing
strategy was also revised
The finishing strategy was revised with cycle 252
Cycle 275 has been expanded with parameters Q369 and Q439
Further information: Cycle Programming User's Manual
To Next Page
Loading...
