Fundamentals | Control model, software and features
26
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
With the TCH PROBE MONITOR OFF soft key you can suppress
touch-probe monitoring for 30 seconds, see "Suppress touch
probe monitoring", page 543
During manual probing ROT and P, workpiece misalignment can
be compensated by aligning a rotary table, see "Compensation
of workpiece misalignment by rotating the table", page 557,
see "Corner as preset", page 564
If the function for orienting the touch probe to the programmed
probe direction is active, the number of spindle revolutions
is limited when the guard door is open. In some cases, the
direction of spindle rotation will change so that positioning will
not always follow the shortest path.
It is now also possible to transfer undefined parameters with
the D00 function
With D16, it is possible to enter references to Q parameters or
QS parameters as the source and target, see "D16 – Formatted
output of texts and Q parameter values", page 357
The D18 functions have been expanded, see "D18 – Reading
system data", page 363
New machine parameter iconPrioList (no. 100813) for defining
the order of icons in the status display, see "Machine-specific
user parameters", page 658
The machine parameter clearPathAtBlk (no. 124203) enables
you to specify whether the tool paths will be cleared with a
new BLK FORM in the Test Run operating mode, see "Machine-
specific user parameters", page 658
New optional machine parameter CfgDisplayCoordSys (no.
127500) for selecting the coordinate system in which a datum
shift is to be shown in the status display, see "Machine-specific
user parameters", page 658
To Next Page
Loading...
