HEIDENHAIN TNC 320 - Page 54

Contents
54
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
17 Tables and Overviews..................................................................................................................657
17.1 Machine-specific user parameters....................................................................................................658
Application............................................................................................................................................658
17.2 Connector pin layout and connection cables for data interfaces..................................................672
RS-232-C/V.24 interface for HEIDENHAIN devices..............................................................................672
Non-HEIDENHAIN devices...................................................................................................................674
Ethernet interface RJ45 socket........................................................................................................... 674
17.3 Technical Information.........................................................................................................................675
User functions......................................................................................................................................676
Software options.................................................................................................................................. 679
Accessories.......................................................................................................................................... 680
17.4 Overview tables................................................................................................................................. 681
Fixed cycles..........................................................................................................................................681
Miscellaneous functions...................................................................................................................... 682
17.5 Functions of the TNC 320 and the iTNC 530 compared................................................................ 684
Comparison: Specifications..................................................................................................................684
Comparison: Data interfaces................................................................................................................684
Comparison: PC software.................................................................................................................... 685
Comparison: User functions................................................................................................................ 685
Comparison: Miscellaneous functions................................................................................................. 693
Comparator: Cycles..............................................................................................................................695
Comparison: Touch probe cycles in the Manual operation and Electronic handwheel modes of
operation...............................................................................................................................................697
Comparison: Probing system cycles for automatic workpiece control................................................698
Comparison: Differences in programming........................................................................................... 700
Comparison: Differences in Test Run, functionality.............................................................................703
Comparison: Differences in Test Run, operation................................................................................. 704
Comparison: Differences in Manual Operation, functionality.............................................................. 705
Comparison: Differences in Manual Operation, operation...................................................................706
Comparison: Differences in Program Run, operation.......................................................................... 706
Comparison: Differences in Program Run, traverse movements.........................................................707
Comparison: Differences in MDI operation......................................................................................... 712
Comparison: Differences in programming station............................................................................... 712
17.6 DIN/ISO function overview...............................................................................................................713
DIN/ISO Function Overview TNC 320................................................................................................. 713