Test Run and Program Run | Graphics
15
590
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
3-D view in the Test Run operating mode
The Test Run mode of operation also offers the following views:
Soft keys Function
Volume view
Volume view and tool paths
Tool paths
The Test Run operating mode also provides the following functions:
Soft keys Function
Show workpiece blank frame
Highlight workpiece edges on 3-D model
Show a transparent workpiece
Show the end points of the tool paths
Show the block numbers of the tool paths
Show the workpiece in color
Reset the volume model
Reset the tool paths
Display the rapid traverse movements
Activate measuring
If measuring is activated, the control shows
the corresponding coordinates in close proxim-
ity if you position the mouse cursor on the 3-D
graphics of the workpiece.
The control saves the state of the following soft keys in non-volatile
memory, even after interruption of the power supply:
Movements at rapid traverse
Workpiece blank frame
Workpiece edges
Transparent workpiece
Workpiece in color
To Next Page
Loading...
