Test Run and Program Run | Program run
15
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
617
Block scan in a point table
If you start in a point table called by the main program, use the
ADVANCED soft key.
Press the BLOCK SCAN soft key
The control shows a pop-up window.
Press the ADVANCED soft key
The control expands the pop-up window.
Point number = enter the line number of the
point table you start with
Enter the Point file = name and path of the point
table
Press the NC Start key
If you would like to start with the mid-program startup in a point
pattern, then proceed just as you would for starting in the point
table. Enter the desired point number in the Point number = input
field. The first point in the point pattern has the point number 0.
To Next Page
Loading...
