HEIDENHAIN TNC 320 - Page 87

Introduction | Status displays
2
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
87
General program information (PGM tab)
Soft key Meaning
No direct
selection
possible
Name and path of the active main program
Actual/nominal value counter
Circle center CC (pole)
Dwell time counter
Current machining time
Current time
Active programs
Program section repeats and subprograms (LBL tab)
Soft key Meaning
No direct
selection
possible
Active program section repeats with block
number, label number, and number of
programmed repeats/repeats yet to be run
Active subprograms with block number in
which the subprogram was called and the label
number that was called
Information on standard cycles (CYC tab)
Soft key Meaning
No direct
selection
possible
Active fixed cycle
Active values of Cycle 32 Tolerance
Active miscellaneous functions M (M tab)
Soft key Meaning
No direct
selection
possible
List of the active M functions with fixed
meaning
List of the active M functions that are adapted
by your machine manufacturer