Heras HMD230+IGD - Display of Operating Modes

www.heras.com
English
24
9.6 DISPLAY OF OPERATING MODES
The following options are available as regards displaying operating modes on the LCD screen:
Display reading Meaning
HMD230 Pe:x.xx
Start indication of the periphery controller
(wait for information from the motor controller)
Init/ClearEEPROM
WAIT: 120 sec.
Clear and initialize the parameter memory
Load Parameter
Request to load/save parameters
Heras HMD230
Automatic mode
Automatic operating mode, the gate is now in the idle position
Automatic mode
Open
Automatic mode; gate opening active
Automatic mode
Close
Automatic mode; gate closing active
Automatic mode
Stop immediately
Automatic mode; STOP active
Automatic mode
Close: xx
Automatic mode; the gate closes automatically after XX
seconds
Heras HMD230
Dead man's operation
Idle position for dead man's operation
Dead man's operation
Open
Open gate in dead man's operation mode active
Dead man's operation
Close
Close gate in dead man's operation mode active
Dead man's operation
Stop immediately
Dead man's operation STOP active
Heras HMD230
Emergency operation
Idle position for emergency operation
Emergency operation
Open
Emergency operation; gate opening active
Emergency operation
Close
Emergency operation; gate closing active
Emergency operation
Stop immediately
Emergency operation; STOP active