Heras HMD230+IGD - 10.5.3 CALENDAR FUNCTIONS

www.heras.com
English
41
turning
press
briefly
S
e
c
o
n
d
V
a
l
u
e
:
4
5
turn CW
press
briefly
S
e
t
D
a
t
e
/
T
i
m
e
D
a
y
l
i
g
h
t
S
a
v
i
n
g
turning
press
briefly
Set to "1" (default) for
automatic summer time
switch-over according to the
EU rules.
D
a
y
l
i
g
h
t
S
a
v
i
n
g
V
a
l
u
e
:
1
turning
press
briefly
S
e
t
D
a
t
e
/
T
i
m
e
N
o
w
D
a
y
l
i
g
h
t
S
a
v
?
turning
Set "0" in winter; and set to
"1" if the summer time has
started
N
o
w
D
a
y
l
i
g
h
t
S
a
v
?
V
a
l
u
e
:
1
press
and hold
press
briefly
Exit the main menu.
The control software is
restarted.
M
a
i
n
M
e
n
u
Q
U
I
T
M
e
n
u
10.5.3 Calendar functions of the motor drive
In automatic mode, the calendar functions of the master drive can be used to influence the gate
behavior in different ways at specific times. Only available for profiles 3+4.
Some commands are available for gate actions. They can be called up at carefully defined times.
The times and commands can be repeated for the seven week days, with a weekly cycle.
However, other combinations of times and commands of a higher priority (e.g. for holidays) can be
planned in a yearly calendar to suppress this weekly recurring time process. This enables the
automatic gate behavior to be defined individually in advance by making the relevant calendar
entries.
Information: The calendar function in the motor drive control system is a paid option which
must be enabled by the engineer once and is then available to the customer. Otherwise, the
calendars will not be visible.
Note: When programming, beware that "Automatic closing" is the default gate mode. The function to
be programmed forms an exception to this behavior. Every function must have a start time and an
end time.