Heras HMD230+IGD - Menu 4.1.3: Keep Part OPEN Timer

www.heras.com
English
35
press
briefly
turn CW
T
M
R
K
e
e
p
O
p
e
n
V
a
l
u
e
:
9
9
9
press
briefly
S
e
t
T
i
m
e
r
2
T
M
R
K
e
e
p
O
p
e
n
press
and hold
press
briefly
Exit the main menu.
The control software is
restarted.
M
a
i
n
M
e
n
u
Q
U
I
T
M
e
n
u
Example: If the "Keep-open TMR" parameter is set at value 5, a 5-second timer is started when the
gate reaches its OPEN end position in automatic mode. This timer causes the gate to be closed
automatically again after 5 seconds. If another OPEN command is given or an installed photocell is
activated during this time, the timer will start to count down again. This also applies to loop detection
and anti-crushing safety protection devices.
10.4.1.3 Menu 4.1.3: Keep Part OPEN timer
The motor drive can close the gate automatically after a time as set (1 to 255 seconds) has elapsed
after the Part OPEN position was reached. This function is active only in automatic mode and after the
Part OPEN position has been reached.
Menu Action Display reading Explanation
H
e
r
a
s
H
M
D
2
3
0
S
1
E
N
A
u
t
o
m
a
t
i
c
M
o
d
e
4
press
and hold
turn CW
Activate the main menu.
M
a
i
n
M
e
n
u
4
S
e
t
t
i
n
g
s
4.1
press
briefly
S
e
t
t
i
n
g
s
1
S
e
t
T
i
m
e
r
4.1.3
press
briefly
turn CW
S
e
t
T
i
m
e
r
3
T
M
R
K
e
e
p
P
a
r
t
O
p
press
briefly
Set the required time in
seconds. (1- 255 seconds)
T
M
R
K
e
e
p
P
a
r
t
O
p
e
n
V
a
l
u
e
:
2
5
5