10.7 LED lighting operation
The iGate can optionally be provided with RGB LED strips. The light color can be set on the LED
control unit. The LED lights will only switch on if the gate is closed. The lights can be activated at a
specific time, using a separate week timer (optional). This enables you to set the gate lights such that
they are only on at night. This can also be done automatically using a light/dark switch. When
darkness falls, the lights on the gate will go on.
See the manuals for the LED control unit and the week timer for instructions on how to
operate and program them.
Illustration 24: LED control unit
Illustration 25: Week timer
If the gate has not been used for some time, the lights on the gate may not work or may work
poorly. Open and close the gate automatically 3x then. This will clean the contacts, causing
the lights to work normally.
If this does not solve the problem, contact the Service Department.
See the chapter on "
SERVICE / MAINTENANCE" for the technical specifications.
To Next Page
Loading...