Marker plate
Illustration 21: Marker plate on a uGate and an Orion
Marker plate
Illustration 22: Marker plate on iGate
Attention: If there is a power failure while the gate is being moved, it may no longer be
possible to save the gate position. This is indicated by the fact that the gate can no longer be
moved in automatic mode. You must then also manually move the gate to its CLOSED position
and set the position again.
10.5 MENU 5 - CLOCK/CALENDAR
The clock module integrated in the HMD230 can be used to move the gate automatically, on the basis
of an exact time schedule.
If the power supply to the motor drive is switched off, the date and time are kept up to date for a
couple of weeks. Automatic switch-over to summer or winter time take place, according to EU rules.
As a result, the clock is put forward one hour at 2 a.m. CET on the last Sunday of March and it is put
back one hour at 3 a.m. CET on the last Sunday of October.
To Next Page
Loading...