Heras HMD230+IGD - Menu 6.1: Displaying the Number of Hand Transmitters

www.heras.com
English
56
 "CLOSE function" right-hand top key
 "STOP function" large bottom key
 "PART OPEN function"* simultaneously press and
hold the left and right keys
* Only in combination with an activated
"Part open" position
Illustration 23: Heras transmitter
The keys can also be individually programmed, see “Teaching hand transmitters”.
Editing options (like teaching the hand transmitter and deleting) are available via the menu structure
of the motor drive. A maximum of 150 hand transmitters can be taught.
Information: Gate movements can only be activated by means of the remote control if the
motor drive is working in automatic mode.
An external antenna must be connected to the corresponding connector of the motor drive
PCB (
see illustration 13, pos. 9).
The internal core of the coax cable of the antenna is connected to the right-hand terminal
(near the housing side). The antenna shield is connected to the most inward/left-hand
terminal.
10.6.1 Menu 6.1: Displaying the number of hand transmitters
A separate storage location is reserved in the memory of the motor drive for each hand transmitter.
The total number of transmitters stored can be displayed by means of the menu option "Active
transmitters".
Menu Action Display reading Explanation
H
e
r
a
s
H
M
D
2
3
0
S
1
E
N
A
u
t
o
m
a
t
i
c
M
o
d
e
6
press
and hold
turn CW
Activate the main menu.
M
a
i
n
M
e
n
u
6
R
F
R
e
m
o
t
e
C
t
r
l
6.1
press
briefly
R
F
R
e
m
o
t
e
C
t
r
l
.
1
A
c
t
i
v
e
T
r
a
n
s
m
i
press
briefly
Display of the number of
hand transmitters taught.
A
c
t
i
v
e
T
r
a
n
s
m
i
t
.
0
press
and hold
press
briefly
Exit the main menu.
The control software is
restarted.
M
a
i
n
M
e
n
u
Q
U
I
T
M
e
n
u