36
•
Do not apply any soap solution, oil or grease
inside the USB charger.
•
Any personal belongings have to be removed
before water washing to avoid damage.
NOTE
•
Engine oil level-Check and top up engine
oil if required (page 49). Check for leaks.
Inspect your vehicle every day before you start
the engine. The items listed here will only take
a few minutes, and in the long run they can
save time, expense, and possibly your life.
Please follow the tips as given below:
•
Front brake-Check for correct brake fluid level
in master cylinder/reservoir (page 60).
You should conduct pre ride inspection before
riding the vehicle to enhance riding comfort
and safety.
Clean your vehicle regularly. It protects the
surface finish. Avoid cleaning with products
that are not specifically designed for vehicle
surfaces.
•
Programmed FI malfunction indicator
lamp (MIL)-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp (MIL)
glows continuously and then should go
“OFF” once the engine is started.
•
Fuel level-Ensure sufficient fuel is available
in your fuel tank for journey. Fuel level
segment should be above one segment
blinking (page 22). Check for leaks
PRE- RIDE INSPECTION
(1) USB charger (2) Cap
(3) USB device compartment
1
3
2
•
Multiple charging of USB devices have to be
avoided, simultaneous charging may lead to
slow or no charging.
•
Do not leave the USB device and USB cable
in the USB device compartment when the
vehicle is parked.
•
Charge your device only when the engine is
operational/while riding. Charging the USB
device when the engine is “OFF” would lead
to early discharge of battery.
•
Always place the device in a soft clean
cloth/towel to avoid any damage due to road
shocks while riding.
•
This port is for charging compatible USB
devices.
CAUTION
!!
•
Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
•
Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
To Next Page
Loading...
