60
CAUTION
!!
• While lubricating and cleaning hold the rear
wheel with one hand to prevent the
possibility of your finger being trapped
between the chain and sprocket.
• The drive chain is fitted with O-rings
between the link plates. These O-rings
retain grease inside the chain to improve its
service life. However, special precautions
must be taken when adjusting, lubricating,
washing and replacing the chain.
• If the chain is excessively dirty, it should be
removed and cleaned before lubrication. For
your own safety, we recommend that service
be performed by an Authorised Hero
MotoCorp workshop.
• Clean and lubricate the chain, whenever
possible, after riding the vehicle under rain
or in terrain with excessive dust, mud or
sand.
• Steam cleaning, high pressure washers and
certain solvents can damage the drive chain
O-rings.
Check the chain slider (1) for wear, The chain
slider must be replaced if wear limit is reached.
DRIVE CHAIN SLIDER INSPECTION
(Refer to “Maintenance Schedule” on page
45).
For replacement, see your Authorised Hero
MotoCorp workshop.
Brake fluid recommended:
BRAKES
Refer to the safety precautions on (page 44).
(a) Front brake
Master Cylinder/ (1)Reservoir
Location : Right handlebar.
DoT-4/DoT-3.
1
(1) Chain slider (2) Wear limit
22
(1) /reservoir Master cylinder (2) Lower mark
1
2
To Next Page
Loading...
