HERO XPULSE 200 PROGRAMMED FI - BASIC TROUBLESHOOTING; Engine Starting Issues

Check fuse
Inspect battery
Check connections, ignition switch/starter switch
OK
OK
OK
Loose
Replace fuse (page 70)
Refill
Secure connections
Weak
Fused
Consult Authorised WorkshopHero MotoCorp
D. Electric Starter Not Working
Consult Authorised WorkshopHero MotoCorp
74
BASIC TROUBLESHOOTING
1. STARTING TROUBLE - ENGINE DOES NOT START
Check engine stop/kill switch position
“OFF”
A. Engine Stop/Kill Switch Position
Consult Authorised Hero MotoCorp Workshop
Turn to “ON” ( ) position
“ON” ( ) position
Key “ON” position
Check for operating sound of fuel pump
Broken fuel pump wire connector
Refill the fuel tank
Secure connections
Leakage
One segment blinking displayed
C. Fuel System
Consult Authorised WorkshopHero MotoCorp
Refill
Consult Authorised WorkshopHero MotoCorp
Check fuel gauge
Check fuel lines
OK
OK
Check side stand in gear condition (page 32)
Side stand“Down”
B. Side Stand Engine Kill System
Consult Authorised Hero MotoCorp Workshop
Move the side stand up
Side stand “Up”