HERO XPULSE 200 PROGRAMMED FI - Engine Stalling and Poor Pick Up

BASIC TROUBLESHOOTING
Spark plug loose in cylinder head
OK
Check air cleaner element
OK
OK
Check brake binding
Tighten the spark plug
Clean & Refit
Dirty/Clogged
Loose
3. POOR PICK UP
OK
Check tyre inflation pressure
Under inflated
Correct tyre pressure
Consult Authorised Hero MotoCorp Workshop
Improper functioning
Consult Authorised Hero
MotoCorp Workshop
75
OK
Check air cleaner element
OK
Clean & Refit
Dirty/Clogged
Leakage
Consult Authorised Hero MotoCorp Workshop
2. ENGINE STARTS BUT STALLS
Consult Authorised Hero MotoCorp Workshop
Check fuel lines
Check ignition switch
OK
OK
OK
D. No Spark At Spark Plug
No spark
Consult Authorised WorkshopHero MotoCorp
Check spark plug for fouling/
improper electrode gap
Replace spark plug/adjust
Spark plug gap (0.8-0.9 mm)
Loose contact
Check for poorly connected
or loose spark plug wire
Secure properly
“OFF” ( ) position
Turn ignition switch “ON” ( )