HERO XPULSE 200 PROGRAMMED FI - Brake Pad Wear Inspection

62
•
If either pad is worn to the bottom of the
grooves replace both pads as a set. Visit
your Authorised Hero MotoCorp workshop
for this service.
Brake pad wear depends upon the severity of
usage, type of riding & road conditions.
Generally, the pads will wear faster on wet &
dirty roads. Inspect the pads at each regular
maintenance interval.
Front brake
(c) Brake pad wear
•
Check the brake pads for wear by
examining the wear indicator groove (1) on
each pad.
Check the wear indicator groove (1) in each
pad.
Rear brake
If either pad is worn to the bottom of the
groove, replace both as a set. Visit your
Authorised Hero MotoCorp workshop for this
service.
(1) Wear indicator groove
1
(1) Wear indicator groove
1
(3) Rear brake caliper (4) Brake pads (5) Disc
5
4
NOTE
• Clean the dirt and mud accumulation
between the rear brake caliper (3), brake
pads (4) and the disc (5) by using a water jet.
• Always contact Hero your Authorised
MotoCorp reservoirworkshop for refilling of
when necessary. Do not mix DoT 3 and DoT
4 brake fluid.
3