What does error '-4-' mean on Hettich Laboratory Equipment and how to fix it?
If your Hettich Laboratory Equipment displays error '-4-', it signals a communication error in either the control or power section. Perform a MAINS RESET to resolve this issue.
How to fix no display on Hettich Laboratory Equipment?
If your Hettich Laboratory Equipment's display is not working, it could be due to no power or defective mains input fuses. Check the supply voltage and the mains input fuse. Also, ensure the mains switch is set to [I].
What to do if Hettich ROTOFIX 32 A Laboratory Equipment displays error '-2-'?
If your Hettich Laboratory Equipment shows error '-2-', it means there was a loss of mains power during the centrifugation run, and the run was not completed. You should open the lid and press the [START] button. If necessary, repeat the centrifugation run.
Defines the centrifuge's intended purpose and application.
Details user qualifications and requirements.
Provides critical safety warnings and procedures.
Guide to setting up and connecting the centrifuge.
Procedure for powering the centrifuge on/off.
Guide for safe rotor removal and installation.
Guidelines for loading centrifuge tubes into rotors/buckets.
Procedures for performing centrifugation runs.
How to set and adjust centrifugation parameters.
Detailed instructions for cleaning and disinfecting the device.
Procedures for routine maintenance.
Table of common faults, causes, and remedies.
Steps to perform a main power reset.
General| Brand | Hettich |
|---|---|
| Model | ROTOFIX 32 A |
| Category | Laboratory Equipment |
| Language | English |
To Next Page