HEX ezCAN - Husqvarna

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 37 of 60 ezCAN 2408.x
Adjusting Aux 1 lights
only
1. Press and hold the Joystick button UP until the Aux 1
lights flash twice.
 The Aux 1 lights are now in brightness-adjustment
mode.
2. Briefly press and release the Joystick button UP to
increase light brightness by 10% per press (to a
maximum of 100%), or DOWN to decrease brightness
by 10% per press (to a minimum of 0%).
3. Exit brightness-adjustment mode by not operating the
Joystick button for more than 5 seconds.
Adjusting Aux 2 lights
only
1. Press and hold the Joystick button DOWN until the Aux
2 lights flash twice.
 The Aux 2 lights are now in brightness-adjustment
mode.
2. Briefly press and release the Joystick button UP to
increase light brightness by 10% per press (to a
maximum of 100%), or DOWN to decrease brightness
by 10% per press (to a minimum of 0%).
3. Exit brightness-adjustment mode by not operating the
Joystick button for more than 5 seconds.
Toggling Aux 1 lights
On and Off
Press and hold the turn-signal cancel button for more than 3
seconds. The state of the lights persists even if the ignition is
cycled.
Toggling Aux 2 lights
On and Off
Click the turn-signal cancel button three times. The state of
the lights persists even if the ignition is cycled.
Temporarily switching
off all front and rear
auxiliary lights
Press and hold the turn-signal cancel button for more than 10
seconds.
If all front and rear auxiliary lights are temporarily switched
off, the ezCAN will turn the rear auxiliary lights back on:
 Whenever Aux 1 or Aux 2 lights are turned back on.
 After the ignition switch is cycled.
Strobing Aux lights on
‘Flash-to-pass’
Click the motorcycle’s ‘Flash-to-pass’ button four times.
Note that to be active, this function must be enabled using
the ezCAN configuration interface.
5.1.6 Husqvarna
5.1.6.1 ezCAN II Scandes
Applicable models:
NOTES
If all front and rear auxiliary lights are temporarily switched
off (see table above), these lights will be switched back on
when the ignition is cycled.
Alternatively, Aux1 and/or Aux 2 lights can be switched
back on using the Toggling Aux 1/2 lights On and Off
functions (see table above).
When using the Toggling Aux 1/2 lights On and Off
functions, note that any rear auxiliary (Run/Brake) lights will
be switched back on whenever Aux 1 and/or Aux 2 lights
are switched back on.