HEX ezCAN - Ktm

Hex ezCAN for CAN-bus-equipped Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate (UK) Ltd. Page 28 of 60 ezCAN 2408.x
Adjusting Aux 2 lights
only
1. Press and hold the left switchgear TRIP or trigger button
until all auxiliary front lights flash twice.
 The auxiliary front lights are now in brightness-
adjustment mode.
2. Release the TRIP or trigger button.
3. Pull in and hold the clutch lever.
4. Briefly press and release the TRIP or trigger button to
adjust light brightness.
 Each press will brighten the Aux 2 lights by 10%
to a maximum of 100%, then roll brightness
through to 0% (OFF).
 You can repeat this cycle as many times as you
need.
5. Release the clutch lever.
6. Exit brightness-adjustment mode by not operating the
TRIP or trigger button for more than 5 seconds.
Toggling Aux 1 lights
On and Off
Press and hold the left switchgear TRIP or trigger button for
more than 7 seconds. The state of the lights persists even if
the ignition is cycled.
Toggling Aux 2 lights
On and Off
1. Pull in and hold the clutch lever.
2. Press and hold the left switchgear TRIP or trigger button
for more than 7 seconds. The state of the lights persists
even if the ignition is cycled.
Temporarily switching
off all front and rear
auxiliary lights
Press and hold the left switchgear TRIP or trigger button for
more than 10 seconds.
If all front and rear auxiliary lights are temporarily switched
off, the ezCAN will turn the rear auxiliary lights back on:
 Whenever Aux 1 or Aux 2 lights are turned back on.
 After the ignition switch is cycled.
Strobing Aux lights on
‘Flash-to-pass’
Click the motorcycle’s ‘Flash-to-pass’ button three times.
Note that to be active, this function must be enabled using
the ezCAN configuration interface.
5.1.3 KTM
Two different ezCANs have been released for KTM:
 ezCAN II for KTM (full support for all 1050, 1090, 1190 and 1290
models up to model year 2020; partial support for 790 models.)
NOTES
If all front and rear auxiliary lights are temporarily switched
off (see table above), these lights will be switched back on
when the ignition is cycled.
Alternatively, Aux1 and/or Aux 2 lights can be switched
back on using the Toggling Aux 1/2 lights On and Off
functions (see table above).
When using the Toggling Aux 1/2 lights On and Off
functions, note that any rear auxiliary (Run/Brake) lights will
be switched back on whenever Aux 1 and/or Aux 2 lights
are switched back on.