High End Systems x.Spot - Page 102

6-4 General Maintenance x.Spot ™User Manual
PANSLOT
PAN HOMING
SLOT NOT FOUND
Top box 3-phase board
Pan or Tilt is not homing correctly:
1. Check that there are no obstructions keeping the unit from correcting
position.
2. Check wiring connections.
– Sensor wire at sensor and board HD6.
– Motor wire at motor and board M1.
– Encoder wire at encoder and board HD7.
3. Replace with another 3-phase board to check for board malfunction,
see “Replacing a Driver Board” on page 5-6.
4. Check that the Sensor is installed and undamaged.
5. Check for sensor wire damage.
6. Check for a broken belt.
7. Check for wire harness or encoder damage.
8. Replace motor.
TILTENCD
TILT ENCODER
TIMEOUT
Head 3-phase board
EDGEDIM1
DIM 1 HOMING
OPEN NOT FOUND
Upper dim flag on side opposite
Tilt board.
Dim flags are not homing correctly:
1. Check for obstruction to dim flag movement.
2. Verify color mix board operation by switching with another
2-phase board from the fixture, see “Replacing a Driver Board” on
page 5-6.
3. Check Dim flag motor wire connection at motor and M1 on Color Mix
board.
4. Check Dim sensor S1 connection at sensor and board.
5. Check that Dim flag sensor is installed, undamaged and operating.
6. Check that Dim flag set screw is tight.
7. Check for wire harness damage.
OPENDIM1
EDGEDIM2
DIM 2 HOMING
OPEN NOT FOUND
Lower dim flag on side with Tilt
board.
OPENDIM2
Display Error Messages
8 Character
Error Message
16 Character Error
Message
Location
Problem/Procedure
For replacement parts, see “Contacting High End Systems®” on page ii