x.Spot ™User Manual General Maintenance 6-5
6
CTO TAB
CTO HOMING TAB
NOT FOUND
Color mix module 2-phase board
M2 on Tilt board side of fixture.
Color mix wheel is not homing correctly:
1. Check if broken Color mix wheel is or another obstruction is
preventing tab from being found.
2. Check connection of Color mix sensor S2 at sensor and board.
3. Check Color mix wheel wire connections to motor and board.
4. Check for Color mix board malfunction by substituting another
2-phase boards from the fixture, see “Replacing a Driver Board” on
page 5-6.
5. Check that Color mix wheel homing Wheel sensor is installed.
6. Check that Set screws on color mix wheel hub and color mix drive
gear hub are tight.
7. Check that Drive gear is aligned with wheel gear.
8. Check for a missing thrust washer causing two wheels to move
simultaneously.
9. Check for dead color mix sensor, color mix board, color mix motor.
10.Check for Color mix wire harness damage.
COLOR
COLOR 1 HOMING
TAB NOT FOUND
Color mix module 2-phase board
M3 on Tilt board side of fixture.
CYAN
CYAN HOMING
TAB NOT FOUND
Color mix module 2-phase board
M4 on Tilt board side of fixture.
MAGENTA
MAGENTA HOMING
TAB NOT FOUND
Color mix module 2-phase board
M2 on side opposite tilt board.
CTB TAB
CTB HOMING
TAB NOT FOUND
Color mix module 2-phase board
M3 on side opposite tilt board.
YELLOW
YELLOW HOMING
TAB NOT FOUND
Color mix module 2-phase board
M4 on side opposite tilt board.
Display Error Messages
8 Character
Error Message
16 Character Error
Message
Location
Problem/Procedure
For replacement parts, see “Contacting High End Systems®” on page ii
To Next Page
Loading...
