Network Video Recorder User Manual
178
Step 1 Go to System > Network > Advanced > Email.
Figure 16-7 Email Settings
Step 2 Configure the following Email settings.
● Enable Server Authentication: Check to enable the function if the SMTP server requires user
authentication and enter user name and password accordingly.
● SMTP Server: The IP address of SMTP Server or host name (e.g., smtp.263xmail.com).
● SMTP Port: The SMTP port. The default TCP/IP port used for SMTP is 25.
● Enable SSL/TLS: Check to enable SSL/TLS if required by the SMTP server.
● Sender: The name of the sender.
● Sender's Address: Sender's Address.
● Select Receivers: Select the receiver. Up to 3 receivers can be configured.
● Receiver: The name of the receiver.
● Receiver's Address: The Email address of user to be notified.
● Enable Attached Picture: Check to enable the function if you want to send email with attached
alarm images. The interval is the time between two adjacent alarm images.
Step 3 Click Apply.
Step 4 (Optional) Click Test to send a test email.
To Next Page
Loading...
