Video Security Control Panel User Manual
2) The LED keypad is considered as off-line in the communication. If there is other keypad
operates normal, process program command {Main Operator Password} + {*} + {6} + {8} + {#}
to restore it or power off the control panel and reboot.
Q: How does the control panel detect alternating current, storage battery, control panel tamper-proof and ADSL
cable?
A: The status of the control panel detection is as follows:
1) The control panel detects AC power supply status once in a while;
2) The control panel detects storage battery status once in a while;
3) The control panel detects tamper-proof status once in a while;
4) The control panel detects ADSL cable status once in a while.
Q: The network is disconnected.
A：
1) Please check if the network status indicator of the board is normal on;
2) If the network status indicator is not normal on, please check if the network cable connection
is normal.
Q: What if the client cannot log in the device?
A: Troubleshoot according to the prompt.
Please check if the device IP Address and Port No. are correct. The device default IP Address is:
192.0.0.64, and the Port No. is: 8000.
Please check if the user name and password to log in the control panel are correct. The default user
name is: admin, the word is: 12345.
Q: Why the control panel cannot communicate with the alarm center group?
A: The configuration of control panel communicating with the alarm center group is as follows:
1) If the user communicates with the center via LAN: Configure parameters such as monitoring IP,
Port No., User Account and Communication Protocols of the remote alarm center in Remote
Settings-> Others-> Network Center Settings;
2) If the user communicates via dialing: Configure parameters such as phone number, receiver
identity account and communication protocols of the remote alarm center in Remote
Settings-> Others-> Dialing Parameter Setting;
3) If the user communicates via WIFI: Configure APN Name and Parameters of remote alarm
center in Remote Settings-> Others-> WIFI Parameter Setting. The parameters include
monitoring IP, Port No., User Account and Communication Protocol, etc.;
4) After setting dialing parameters, LAN parameters and WIFI parameters, configure the
To Next Page
Loading...
