Video Security Control Panel User Manual
uploading mode in Remote Settings-> Uploading Mode Settings
Q: How to configure the communication way of video security control panel and alarm center group?
A:
1. Center uploading mode supports at most 6 center groups, each center group divides in main channel
and 3 backup channels;
2. If the center group is enabled. Enable the center group before the use.
3. For example: The control panel needs to upload report to network alarm center 1 and dialing
alarm center1 and network alarm center 1 needs to upload report to network alarm center 2
when it fails to upload it. The configurations are as follows:
1) Enable Group1 and Group2;
2) In the uploading mode configuration list, select N1 in center group 1 main channel, select N2
in backup channel 1, select T1 in Center group2 main channel.
3) Click Apply.
If the client is not opened, the user can realize communication with alarm center by programming with
keypad. For detailed operations please refer to program command 611~634.
Q: Why cannot it upload report and control after WIFI is enabled?
A: The follow situations may lead to WIWI connection failure:
1) No SIM Card or poor contact;
2) 3G module antenna is not normally connected or with poor signal;
3) WIFI parameter setting is incorrect;
4) SIM Card has no enough tariffs.
To Next Page
Loading...
Need help?
General
