Video Security Control Panel User Manual
{5}~{12} It indicates the start time and end time during the time bucket of {4}.
Start Time: {5}{6}:{7}{8}
End Time: {9}{10}:{11}{12}
When you set the start and end time as 00:00 and 00:00, all the settings from the present time bucket
to the maximum time bucket will be cleared.
When you set the start and end time as non-zero, the previous time bucket must be non-zero.
When you set the start and end time as non-zero, only Arming in {13} can be set.
When you set the start and end time as non-zero, end time must be later than start time in every time
bucket.
When you set the start and end time as non-zero, the start time must be 5min greater than the end
time of the previous time bucket.
When you set the start and end time as non-zero, if the time bucket is overlapped with the latter ones,
or the difference between them is less than 5min, all the settings of the latter ones will be cleared.
{13} Three types of Arming/Disarming.
{14} End the command.
Copy Weekly Schedule
To copy the settings of the day (n) to another day (l) of the week in partition (m), please refer to the command
below.
{1} Copy Weekly Schedule Command Address: 692.
{2} It indicates the partition (m) number. 01~08 indicate partitions No.1~No.8.
{3} It indicates the value range of the day (n).
To Next Page
Loading...
Need help?
General
