User Manual of WIFI Network Video Recorder
129
11.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the General tab.
Figure 11. 1 Network Settings Interface
3. In the General Settings interface, you can configure the following settings: NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
The valid value range of MTU is 500 ~ 9676.
If the DHCP server is available, you can check the checkbox of Enable DHCP to automatically obtain
an IP address and other network settings.
4. Click Apply button to save the settings.
To Next Page
Loading...
