User Manual of WIFI Network Video Recorder
56
5.3 Configuring Motion Detection Recording
Purpose:
In the live view mode, once a motion detection event takes place, the NVR can analyze it and do many actions to
handle it. Enabling motion detection function can trigger certain channels to start recording, or trigger full screen
monitoring, audible warning, notify the surveillance center and so on. In this chapter, you can follow the steps to
schedule a record which triggered by the detected motion.
Steps:
1. Enter the Motion Detection interface.
Menu > Camera > Motion
2. Configure Motion Detection.
1) Choose camera to configure.
2) Check the checkbox of Enable Motion Detection.
3) Use the mouse to drag and draw the motion detection area in the right live view window.
If you want to set the motion detection for all the area shot by the camera, click Full Screen.
To clear the motion detection area, click Clear.
Figure 5. 9 Motion Detection- Mask
4) Click Settings, and the message box for channel information pop up.
Figure 5. 10 Motion Detection Settings
5) Select the channels which you want the motion detection event to trigger recording.
To Next Page
Loading...
