User Manual of WIFI Network Video Recorder
45
2. Select patrol No. in the drop-down list of patrol.
3. Click the Set button to add key points for the patrol.
Figure 4. 7 Key point Configuration
4. Configure key point parameters, including the Preset No., Duration of staying for one key point and Speed
of patrol.
KeyPoint No.: determines the order at which the PTZ will follow while cycling through the patrol.
Preset: PTZ will rotate automatically to the set preset No. when execute the keypoint.
Duration: refers to the time span to stay at the corresponding key point.
Speed: defines the speed at which the PTZ will move from one key point to the next.
5. Click the Add button to add the next key point to the patrol, and you can click the OK button to save the key
point to the patrol.
You can delete all the key points by clicking the Clear button for the selected patrol, or click the Clear All
button to delete all the key pints for all patrols.
4.3.4 Calling Patrols
Purpose:
Calling a patrol makes the PTZ to move according the predefined patrol path.
Steps:
1. Enter PTZ Control interface. For details, please refer to 4.2 PTZ Control Panel.
2. Click the button to show the general settings of the PTZ control.
Figure 4. 8 PTZ Panel - General
3. Select a patrol in the drop-down list and click the Call Patrol button to call it.
4. You can click the Stop Patrol button to stop calling it.
To Next Page
Loading...
