16
Starting and Shutting Down Your DVR
Proper startup and shutdown procedures are crucial to expand the life of your DVR.
To start your DVR:
1. Please make sure the input voltage meets the requirements of DVR, and the GND is in grounding.
2. For DS-7604HI-S and DS-7604NI-S DVR, please make sure the VGA port on its rear panel has connected with a
display device or the VIDEO OUT port has connected to a monitor, or else no prompt message will be displayed
on screen after device startup and the menu operation is inaccessible as well.
3. For DS-7604NI-S/M DVR, please make sure the VIDEO OUT port on its rear panel has connected with a
monitor, or else no prompt message will be displayed on screen after device startup and the menu operation is
inaccessible as well.
4. In case the POWER indicator on the front panel does not light, please apply power to the device to start it.
After the power has been started up, the POWER indicator will light green, and the startup window will appear:
To shutdown the DVR:
1. Enter the Shutdown menu, shown in Figure 1 by clicking on Menu > Shutdown.
Figure 1. Shutdown Menu
2. Select the Shutdown button.
3. Click the Yes button.
Rebooting and Locking Your DVR
While in the Shutdown menu (Figure 1), you may also reboot or lock your DVR. Locking your DVR will return you to
To Next Page
Loading...
Need help?
General