HIKVISION DS-7608NI-L1/W

Chapter 2 Live View
2.1 GUI Introducon
●
Click to start/stop auto-switch. The screen will automacally switch to the next one.
●
Right click a camera, or click
to enter full screen mode.
●
Double click a camera to view it in single-screen mode. Double click again to exit single-screen
mode.
●
When an error occurs, the screen will display the error
descripon. For some errors, you can
click the screen to directly access the resolving
operaons.
●
Change a camera live view screen by dragging it from its screen to the desired screen.
●
Scroll up/down to turn to previous/next screen.
●
Click
to enter temperature detecon interface. Aer specied thermal cameras are
connected, you can view the captured face pictures and temperature detecon results.
●
Posion the cursor on a camera to show shortcut menu.
Figure 2-1 Shortcut Menu
Table 2-1 Shortcut Menu Descripon
Buon Descripon
Start playing videos recorded in the latest ve minutes.
Digital zoom. You can adjust zoom-in mes and view the desired area.
Click it to enter PTZ control mode.
Turn on/o live view audio.
Switch video stream.
●
In the live view interface, there are icons at the upper-right corner of the screen for each
camera, showing the camera recording and alarm status.
Table 2-2 Live View Icon
Descripon
Icon Descripon
Alarming (normal event and smart event).
Recording.
●
Right click your mouse to display the shortcut menu. Provided opons are as follows:
Network Video Recorder User Manual
5