Network Video Recorder User Manual
77
Figure 7-4 Alarm Status Interface of System Configuration
2. Set up the handling action of the selected alarm input.Check Enable and click Settings to set up
its alarm response actions.
Figure 7-5 Alarm Input Setup Interface
3. Enable the one-key disarming for local alarm input 1 (Local<-1).
1) Check Enable One-Key Disarming.
2) Click Settings to enter the linkage action settings interface.
3) Select the alarm linkage action (s) you want to disarm for the local alarm input1. The selected
linkage actions include the Full Screen Monitoring, Audible Warning, Notify Surveillance
Center, Send Email and Trigger Alarm Output.
Note
When the alarm input 1 (Local<-1) is enabled with one-key disarming, the other alarm input
settings are not configurable.
4. Select Trigger Channel and select one or more channels which will start to record/capture or
become full-screen monitoring when an external alarm is input, and click Apply to save the
settings.
5. Select Arming Schedule to set the arming schedule of handling actions.
To Next Page
Loading...
Need help?
General
