HIKVISION DS-7608NI-L1/W

Figure 5-4 Network
2. Set network parameters.
DHCP
If the DHCP server is available, you can enable DHCP to automacally obtain an IP address
and other network sengs from that server.
Auto Obtain DNS
If DHCP is enabled. You can enable Auto Obtain DNS to automacally obtain Preferred DNS
Server and Alternate DNS Server.
3. Click Apply.
5.2.2 Hik-Connect
Hik-Connect provides mobile phone applicaon and plaorm service to access and manage your
connected devices, which enables you to get a convenient remote access to the video security
system.
Steps
1. Go to
Conguraon → Network → Hik-Connect .
2. Turn on Enable. The service terms will pop up.
1) Scan the QR code to read the service terms and privacy statement.
2) Check I have read and agree to Service Terms and Privacy Statement. if you agree with the
service terms and privacy statement..
3) Click OK.
3. Click
to set vericaon code.
4.
Oponal: Enable Plaorm Time Sync, the device will sync me with the plaorm server instead
of NTP server.
5.
Oponal: Enable Stream Encrypon. It requires to enter vericaon code in remote access and
live view aer this funcon is enabled.
6.
Oponal: Edit Server IP.
Network Video Recorder User Manual
20