Network Video Recorder User Manual
40
Chapter 4 Recording
4.1 Configure Parameters
By configuring the parameters you can define the parameters which affect the image quality, such
as the transmission stream type, the resolution and so on.
Before You Start
Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu → HDD → General)
Figure 4-1 HDD-General
Check the storage mode of the HDD.
● If the HDD mode is Quota, please set the maximum record capacity and maximum picture
capacity. For detailed information, see Configure Quota Mode.
● If the HDD mode is Group, you should set the HDD group. For detailed information, see .
Figure 4-2 HDD- Advanced
Steps
1. Enter the Record settings interface to configure the recording parameters:Menu → Record →
Parameters.
To Next Page
Loading...
Need help?
General
