HIKVISION DS-K1T341B Series User Manual

Note
• The displayed parameters may vary for
dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
• Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
Alarm of Max. Failed Aempts
Enable to report alarm when the card reading aempts reach the set value.
Card Reader Type/Card Reader Descripon
Get card reader type and descripon. They are read-only.
Advanced
Enable Card Reader
Enable the funcon and e device can be used as an card reader.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to
the card reader parameters. Generally, adopts the default
sengs.
Max. Interval When Entering PWD
When you inpung the password on the card reader, if the interval between pressing
two digits is larger than the set value, the digits you pressed before will be cleared
automacally.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
Communicate with Controller Every
When the access control device cannot connect with the card reader for longer than
the set me, the card reader will turn oine automacally.
Face 1:N Matching Threshold
Set the matching threshold when authencang via 1:N matching mode. The larger the
value, the smaller the false accept rate and the larger the false
rejecon rate when
authencaon.
Face Recognion Interval
DS-K1T341B Series Face Recognion Terminal User Manual
108

HIKVISION DS-K1T341B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341B Series
Category	Touch terminals
Language	English