HIKVISION DS-K1T341B Series

Put the QR code in front of the device camera to authencate via QR code.
Note
Authencaon via QR code should be supported by the device.
If
authencaon completed, a prompt "Authencated" will pop up.
6.7.2 Authencate via Mulple Credenal
Before You Start
Set the user authencaon type before authencaon. For details, see Set Authencaon Mode .
Steps
1. If the authencaon mode is Card and Face, Password and Face, Card and Password,
authencate any credenal according to the instrucons on the live view page.
Note
• The card can be normal IC card, or encrypted card.
• If the QR Code Scanning
funcon is enabled, you can put the QR code in front of the device
camera to authencate via QR code.
2. Aer the previous credenal is authencated, connue authencate other credenals.
Note
For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If authencaon succeeded, the prompt "Authencated" will pop up.
6.8 Basic
Sengs
You can set the shortcut key, voice, me, community No., building No., and Unit No.
Long tap on the inial page for 3 s and slide to the le/right by following the gesture and login the
device home page. Tap Basic.
DS-K1T341B Series Face Recognion Terminal User Manual
41