HIKVISION DS-K1T341B Series

5. Enter the Live View page and double-click the added device to start live view.
Note
For details about operaons in the Live View page, see Live View in the user manual of the
client soware.
6. Right click the live view image to open the right-click menu.
7. Click Start Two-Way Audio to start two-way audio between the device and the client
soware.
6.13.4 Call Room from Device
Steps
1. Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the indoor
staon and the device to the client soware.
Note
For details about adding device, see Add Device.
5. Link a user to an indoor staon and set a room No. for the indoor staon.
6. Call the room.
-
If you have
congured a specied room No. in the Basic Sengs , you can tap to call the
room.
-
If you have not congured a specied room No. in the Basic Sengs , you should tap on
the authencaon page of the device. Enter the room No. on the dial page and tap to call
the room.
7.
Aer the indoor staon answers the call, you can start two-way audio with the indoor staon.
DS-K1T341B Series Face Recognion Terminal User Manual
55