HIKVISION DS-K1T341B Series

6.4.4 Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
1. Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap Wiegand to enter the Wiegand tab.
Figure 6-9 Wiegand Sengs
3. Enable the Wiegand funcon.
4. Select a transmission direcon.
• Output: A face recognion terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 26 or Wiegand 34.
• Input: A face
recognion terminal can connect a Wiegand card reader.
5. Tap to save the network parameters.
Note
If you change the external device, and aer you save the device parameters, the device will
reboot automacally.
6.5 User Management
On the user management interface, you can add, edit, delete and search the user.
6.5.1 Add Face Picture
Add user's face picture to the device. And the user can use the face picture to authencate.
DS-K1T341B Series Face Recognion Terminal User Manual
33