HIKVISION DS-K1T341B Series

Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1.
Click
Conguraon → Access Control → Wiegand Sengs .
Figure 7-13 Wiegand Page
2. Check Wiegand to enable the Wiegand funcon.
3. Set a transmission direcon.
Input
The device can connect a Wiegand card reader.
Output
The can connect an external access controller. And the two devices will transmit the card No.
via Wiegand 26 or 34.
4. Click Save to save the
sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
7.5.14 Set Image Parameters
Set the video standard, WDR, brightness, contrast, saturaon, and sharpness.
Steps
1. Click Conguraon → Image .
DS-K1T341B Series Face Recognion Terminal User Manual
70