HIKVISION DS-K1T341B Series

Figure 8-10 Set Output Transformaon Rule
2) Select rules on the le list.
The selected rules will be added to the right list.
3)
Oponal: Drag the rules to change the rule order.
4) Click OK.
5) In the Custom Wiegand tab, set the rule's start bit, length, and the decimal digit.
7. Click Save.
8.7.5
Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
Steps
1. Click Access Control → Advanced
Funcon → Authencaon to enter the authencaon mode
conguraon page.
2. Select a card reader on the le to congure.
3. Set card reader authencaon mode.
1) Click Conguraon.
DS-K1T341B Series Face Recognion Terminal User Manual
114