HIKVISION DS-K1T341B Series

6.11.2 Set Manual Aendance via Device
Set the aendance mode as manual, and you can select a status manually when you take
aendance.
Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1.
Tap T&A Status to enter the T&A Status page.
2. Set the Aendance Mode as Manual.
Figure 6-15 Manual Aendance Mode
3. Enable the Aendance Status funcon.
Result
You should select the aendance status manually aer authencaon.
Note
If you do not select a status, the authencaon will be failed and it will not be marked as a valid
aendance.
6.11.3 Set Auto Aendance via Device
Set the aendance mode as auto, and you can set the aendance status and its available schedule.
The system will automacally change the aendance status according to the congured
parameters.
Before You Start
Add at least one user, and set the user's authencaon mode. For details, see User Management.
Steps
1. Tap T&A Status to enter the T&A Status page.
2. Set the
Aendance Mode as Auto.
DS-K1T341B Series Face Recognion Terminal User Manual
48