HIKVISION DS-K1T341B Series

Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
6.13.2 Call Center from Device
Steps
1. Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the main
staon and the device to the client soware.
Note
For details about adding device, see Add Device.
5. Set the main staon's IP address and SIP address in the remote conguraon page.
Note
For details about the operaon, see the user manual of the main staon.
6. Call the center.
-
If you have
congured to call center in the Basic Sengs , you can tap to call the center.
-
If you have not congured to call center in the Basic Sengs , you should tap → to call
the center
7. Answers the call via the main staon and starts two-way audio.
Note
The device will call the main staon in priority.
6.13.3 Call Device from Client Soware
Steps
1. Get the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management page.
4. Add the device to the client
soware.
Note
For details about adding device, see Add Device.
DS-K1T341B Series Face Recognion Terminal User Manual
54