To Next Page

To Previous Page

Note

The employee ID cannot be edited.

6.6 Data Management

You can delete data, import data, and export data.

6.6.1 Delete Data

Delete user data.

On the Home page, tap Data → Delete Data → User Data . All user data added in the device will be

deleted.

6.6.2 Import Data

Steps

1. Plug a USB

ash drive in the device.

2. On the Home page, tap Data → Import Data .

3. Tap User Data or Face Data.

4. Enter the created password when you exported the data. If you do not create a password when

you exported the data, leave a blank in the input box and tap OK immediately.

Note

• If you want to transfer all user

informaon from one device (Device A) to another (Device B),

you should export the informaon from Device A to the USB ash drive and then import from

the USB ash drive to Device B. In this case, you should import the user data before imporng

the prole photo.

• The supported USB

ash drive format is FAT32.

• The imported pictures should be saved in the folder (named enroll_pic) of the root directory

and the picture's name should be follow the rule below:

Card No._Name_Department_Employee ID_Gender.jpg

• If the folder enroll_pic cannot save all imported pictures, you can create another folders,

named enroll_pic1, enroll_pic2, enroll_pic3, enroll_pic4, under the root directory.

• The employee ID should be less than 32 characters. It can be a

combinaon of lower leers,

upper leers, and numbers. It should not be duplicated, and should not start with 0.

• Requirements of face picture should follow the rules below: It should be taken in full-face

view, directly facing the camera. Do not wear a hat or head covering when taking the face

picture. The format should be JPEG or JPG. The

resoluon should be 640 × 480 pixel or more

than of 640 × 480 pixel. The picture size should be between 60 KB and 200 KB.

DS-K1T341B Series Face Recognion Terminal User Manual

HIKVISION DS-K1T341B Series User Manual

Questions and Answers: