HIKVISION DS-K1T341B Series

6.4 Communicaon Sengs
You can set the network parameters, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
parameters, and enable 3G/4G on the communicaon sengs page.
6.4.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, and
the gateway.
Steps
1. Tap Comm.
(Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the
Communicaon Sengs page, tap Wired Network.
Figure 6-6 Wired Network Sengs
3. Set DHCP, IP Address, Subnet Mask, or Gateway.
Note
The device's IP address and the computer IP address should be in the same IP segment.
6.4.2 Set Wi-Fi Parameters
You can enable the Wi-Fi funcon and set the Wi-Fi related parameters.
DS-K1T341B Series Face Recognion Terminal User Manual
30