HIKVISION DS-K1T341B Series User Manual

1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3. Select an access control device in the device list and select Linked Capture.
4. Set the picture size and quality.
5. Set the capture
mes once triggered which denes how many pictures will be captures for one
me.
6. If the capture mes is more than 1, set the interval for each capture.
7. Click Save.
Set Manual Capture Parameters
In Status Monitoring module, you can capture a picture manually the access control device's
camera by clicking a buon. Before that, you need to set the parameters for the capture such as
picture quality.
Before You Start
Before
seng the capture parameters, you should set the saving path rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client soware.
Steps
Note
This funcon should be supported by the device
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3. Select an access control device in the device list and select Manual Capture.
4. Select the
resoluon of the captured pictures from the drop-down list.
5. Select the picture quality as High, Medium, or Low. The higher the picture quality is, the larger
size the picture will be.
6. Click Save.
Set Parameters for Face
Recognion Terminal
For face recognion terminal, you can set its parameters.
Steps
Note
This funcon should be supported by the device.
1. Enter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click Face Recognion Terminal.
DS-K1T341B Series Face Recognion Terminal User Manual
121

HIKVISION DS-K1T341B Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341B Series
Category	Touch terminals
Language	English