1
2
3
4
5
6
7
8
9
11
Peripheral Devices
7.2 Using a Printer (Option)
119
• The internal settings for the 9670 PRINTER to be used with
this instrument are as follows.
• As shipped from the factory, the following settings are
selected: Japanese (Language), 9600bps(baud rate) and Auto
Power Off (90 minutes).
• The baud rate, language and auto power off selections are
automatically set by this instrument. Perform Auto printer set-
ting.
• Be aware that changing any other settings may disable hard
copy operation.
Printer Setup
BL-80RS II/RSII [VX.XX] XXXX/XX/XX
SANEI ELECTRIC INC.
*********
Data input = Serial
International char = Japan
Print mode = Graphic
Character set = 24Dot ANK Gothic type
Select switch = Available (ON)
Baud rate = 19200bps
Bit length = 8 bit
Parity= Non
Data control = SBUSY
Paper selection = Normal paper
Upright/inverted = Upright printing
Auto Power Off = Invalidity (OFF)
Battery mode= Invalidity (OFF)
Interface = RS232C
shr=0119 temp=026 shvp=718
After Auto Printer Setup, turn the printer OFF and
back on again.
Setting Item Selections
RS-232C
(baud rate
setting)
PRINTER
9600bps
(slow printing)
19200bps (medium speed printing)
9600bps (fast printing)
All of these are available
HARDWARE
The 9670 PRINTER is automatically set up for use
by the instrument.
Select from pull-
down menu
Select item
Auto Printer
Setup
To Next Page
Loading...
